PCB Drilling and Soldering

WARNING: the things your about to see is just happened to be my first time drilling and soldering.

I'll gave you some advice when your drilling your pcb board.

• Make sure your drill bit is small with the size of 0.4 mm to 0.6mm it is expensive for 70 pesos but it will help you a lot.
• Buy two drill bit
• Be careful when drilling cause you dont want your nails to have holes forever.
• Concentrate all your mind when your drilling cause sometimes it push your copper away and your back to square 1.

Be careful when using the soldering iron because it is FREAKING HOT!!
If your soldering iron is not hot then you buy a new one
It is best recommended that you buy a soldering iron with 40W and above
They broke easily.

When soldering the lead make sure you wont solder the copper too cause the copper will burn and then the lead wont adhere at your board. In my case the lead got stuck with the soldering iron because the copper is too little on the board (because of drilling! I use a big drill bit on those pads on the board that has tiny holes) then the copper became black which you cant use again. Im sure that my circuit wont work if that happens.

They say that a good soldered circuit has the shape of kisses the chocolate one.

well mine dont like that but maybe nearly there.
Hoping for great improvement :)

THANK YOU

HASTA LA PROXIMA VES!!